Overview of vacuum extenders for penis enlargement

vacuum extender for penis enlargement

The purpose of the extenders is the most comfortable lengthening of the penis. The mechanism works only if the head is firmly fixed. How long the device wears depends on how secure and convenient the holder is and, consequently, on the speed of advancement. Vacuum extenders are considered the best option, as is their improved version - vacuum ones. These devices appeared on the market about 10 years ago and have significantly replaced mechanical ones since then.

Construction features and operating principle

In a vacuum extender, the head of the penis is not fixed with a ring or strap, but is sucked by the vacuum into a special bowl (chamber, vacuum nozzle). The device works on the principle of a vacuum pump, but in this case the effect is only on the head and the adjacent area. The air from the chamber, as in the pump, is pumped by a pump or a pear.

The main advantages of models with vacuum fixing:

  • Don't slip;
  • Effectively correct the curvature of the male organ;
  • Do not pinch the head and foreskin;
  • Suitable for micropenis;
  • Comfortable to wear.

The main disadvantage of vacuum-mounted extenders is the appearance of bubbles on the head. This does not happen when it is mechanical. Damage is caused by the delamination of tissues under the influence of vacuum. It is impossible to continue classes until the blisters heal, and since they appear regularly, the effectiveness of using the device decreases significantly.

Many manufacturers complement their products with protective caps to protect the head. Some models are equipped with patch rollers which should be sealed before being inserted into the cap. The bonding and subsequent removal procedure causes discomfort and pain.

Some men complain of the inconvenience of wearing such extenders: the protection is not fixed on the relaxed head, it is necessary to bring the penis to a state of at least partial erection. While wearing the extender, the head decreases, as a result a gap is formed between it and the walls of the hood: the skin is again exposed to the traumatic effects of the vacuum.

Scheme of wearing a vacuum extender:

  1. Seal the head, put a protective cap on it.
  2. Partially spread the silicone case attached to the top of the camera over its body.
  3. Place the penis in the chamber, stretch the silicone sleeve to the end along the shaft.
  4. Remove excess air with a fan or pump.
  5. Fix the penis on the extension rods, adjust the length.

Part of the penis is tightly compressed with silicone, which causes discomfort and cuts off blood flow. The closed area of the trunk is almost not extensive. If the penis is about 12cm, most of it will be under the silicone crimp.

In advanced models with adhesive vacuum attachment, only the head is sucked into the chamber and the sleeve is replaced by soft membranes. The penis and membrane are pre-lubricated with a special lubricant, then the head is brought into the opening of the chamber and sucked into it with several movements of the rubber bulb. Then it is disconnected, the device is firmly fixed on the head. To remove it, simply turn the valve at the top of the chamber. The lubricant adheres the head to the membrane, preventing the formation of gaps, eliminating the appearance of bubbles.

How to use

Before the first fitting of the vacuum extender, the initial length, the size of the erect penis, is set. In the future, the compression force is regulated by the springs on the stems (on spring models): if the ladder is completely visible (the notches are not closed), then there is no tension. If there is no perceptible tension with the rods fully unscrewed, the additional length is increased using the rods included in the kit. The traction force of the stretcher (belt system) can be determined using the household spring scales.

It is impossible to immediately set a large degree of tension: it is possible to compact the albuginea by covering the corpora cavernosa, worsen the erection, edema of the head, lack of growth and even a decrease in the length of the penis. A light adaptive load is administered within a month. The extender is worn for no more than 1-2 hours with a tension force of 200-400g, maximum 500g When the tissues of the penis get used to stretching, it is necessary to switch to a more serious mode: 6-8 hours per day (not necessarily continuous) with a load of 1. 1 kg. You can only wear the extender at maximum length (power pull) from 4 weeks.

Power Growth Program:

  • Unscrew the extender to the length of the erect penis, tension 300-600g;
  • Once worn, the load can increase up to 1 kg;
  • Wear it for 2 hours a day without interruption or spend 2 sessions of 1. 5 hours. One day off per week is required.

It is important to measure the length of the penis (stretched, not erect) after each workout. The increase indicates the effectiveness of the chosen program. If the penis decreases, then it is necessary to rest for 2-3 days.

For a year, with the help of vacuum extenders, it is possible to increase the length of the penis by 3-4 cm and its circumference by 1 cm. In young people, growth occurs faster than in mature men, due to the high elasticity of fabrics. The result also largely depends on the density of the protein coat.

Contraindications

Before buying a vacuum extender, you need to consult a doctor - it will help identify the presence of contraindications to wearing it. The main ones include the following:

  1. Violation of blood clotting, fragile vessels. The vacuum will cause the appearance of hematomas.
  2. Prostate adenoma, prostatitis.
  3. Scrotal hernia.
  4. Sexual infections.

It is dangerous to use vacuum extenders while under the influence of pain relievers, drugs or alcohol. It is undesirable to wear the device at night - in a dream it is easy to miss the moment of the onset of oxygen starvation of tissues due to excessive squeezing, and spontaneous nocturnal erections are also dangerous.

Overview of popular models

Most urologists-andrologists recommend a suction system with vacuum adhesive fixation for penis enlargement to their patients. The soft membrane protects the head from damage by preventing direct exposure to vacuum. The vacuum model is also considered to be comfortable and efficient. The kit includes a camera, a pear, rods, a set of membranes of various sizes, extension rods, gel. There are detailed instructions on how to put on and wear the device correctly. The maximum length of the extender is 32 cm.

There is a kit to upgrade the strap and loop extenders. However, its cost is so high that it is easier to purchase a vacuum extender.

complete set of vacuum extender for penis enlargement

The Korean extender is positioned by the manufacturer as the most comfortable to wear with an additional head enlargement feature. Fixing with adhesive vacuum method. The kit includes 3 membranes, 8 extension pins to be screwed on.

Method of use:

  1. A membrane of suitable diameter is stretched on the edges of the chamber, lubricated with a lubricant (together with the head of the penis);
  2. The camera is mounted on the rods;
  3. The shaft of the penis is placed in the extender, the head is inserted into the chamber;
  4. The pear expels the air.

The device from a Swiss company is a vacuum extender designed for long-term wear. According to men, it is recognized as the most comfortable. The kit includes 3 vacuum chambers with attached condoms, 4 cuffs, 2 protective caps, a pump. The model includes a belt attachment system (stretcher), which allows the extender to be used in public places.

Instructions for Use:

  • A protective cap is put on the head.
  • The penis is inserted between the extension rods, the rods are wrapped until the optimum degree of tension is reached.
  • The head is placed in a suitably sized chamber (a template is attached to determine the size), a condom is rolled over a part of the trunk.
  • An accordion-shaped pump is attached to the chamber, with its help the air is expelled.

If necessary, the rods are removed, a member with a camera on the head is pulled to the belt with a belt.

Some make homemade extenders using bicycle pump cases, plastic, silicone, and plumbing fittings. It is very difficult to make a truly functional and safe device with your own hands. In terms of quality, such crafts are generally inferior to cheap Chinese extenders.

Reviews

Male, 44: "I have been wearing the device with a belt tensioner for six months. The increase in length was 2 cm, a significant result. I do integrate traction with jelqs and hanging weights, but rarely.

Man, 25: "I ordered a Chinese device and I am thinking of returning it or replacing it with a Korean one before it is too late. It is uncomfortable to wear, the penis is squeezed to the point of colic, there is no doubt of its effectiveness in such conditions.

Conclusion

Vacuum extenders from Switzerland, Korea and Germany are officially recognized as effective means for penis enlargement. Equipped with detailed video instructions, which eliminate misuse. It is important to take into account that the regularity of wearing an extender is as important a condition for its success as its quality.